Autocar Self Repair Guides

Took the starter back out and installed it again but still nothing. How to fix a free car that cranks but won t start by.

My Rx8 Won T Start After Flywheel Clutch Install Rx8club Com

Now crank the engine over.

Engine cranks but wont start after replacing clutch. Chrisfix offers a comprehensive sixteen minute video showing viewers how to fix a sputtering vehicle that cranks but won t start. Here are five of the most common causes of a car that cranks yet won t start. If yes it is doubtful the ignition system is the issue.

When unplugging the sensor the engine should not start at all. I have a 01 lx replaced the clutch yesterday and after putting everything back together the car won t start. Believe it or not there are a lot of people who have this problem because they don t have enough fuel in their gas tank.

I m kind of stumped as to what could be causing this. Check the harness to the crankshaft position sensor as it is has a fused wire completing the circuit. I ve replaced the starter alternator and crank shaft sensor and still nothing.

Actually after the vehicle was towed in when the shop attempted to start the vehicle it did start and run but as soon as they tried to drive into the service bay the engine stalled. We received a request to help a shop diagnose a no start vehicle that was sent to them by a neighboring repair shop. It use to start after 2 or 3 times then it just increased from there 4 to 5 times now it won t start at all.

Use a test light to check the spark plug wires for continuity. Check the spark plugs for damage or bad gapping and replace accordingly. If you do not have voltage at this point check the ignition circuit thru the ignition switch fuses and wire harness connections.

This could be attributed to simply not refilling the gas tank or using the wrong fuel type. It cranks but doesn t start almost like there s a kill switch. You should see your test light blink on and off as the engine turns over.

The vehicle was a 2005 honda element that would not start after a clutch replacement. The vehicle was a 2005 honda element that would not start after a clutch replacement. The only thing that can cause the engine to start with the plug off the sensor is the wires are burned and fused together.

If you have voltage at the positive post of coil move your test probe to the negative side of the coil. I have the car listed above se model. I recently replaced the clutch and have been having problems getting it started ever since.

One important piece of this video is chris tells viewers about the three components needed to get the engine revving as a precursor to starting.